Differences

This shows you the differences between two versions of the page.

--- en:workflow [2026/04/15 07:24] – [Here are the steps considered the we-measure.io workflow] benjamin
+++ en:workflow [2026/04/15 16:14] (current) – [Here are the steps considered the we-measure.io workflow] benjamin
@@ Line 20: / Line 20: @@
   - Start a new measurement for your wing
   - Measure the wing either directly into we-measure.io or import measurement data from XLSX
-  - After all the values are measured & checked for plausiblity/consistency, continue to simulation <alert warning>To trim single lines, stay in the open state, trim and remeasure until you have every line in every group as equal as possible, then continue to simulation to get an overview about the overall trim</alert>
+  - After all the values are measured & checked for plausiblity/consistency, continue to simulation <alert warning>To trim single lines, stay in the open state, trim and remeasure until you have every line in every group as close to relative zero as possible, then continue to simulation to get an overview about the overall trim</alert>
   - In simulation, use the different tools to check your wing's trim
   - If you the trim still meets the requirements of the manufacturer, fine! You can just finish the measurement and continue with the last step. <alert warning>If the trim does **not** meet the requirement of the manufacturer anymore, you should hand it in to a professional check center.</alert>