≪ View Page

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
en:workflow [2025/12/16 19:00] – [Workflow] benjaminen:workflow [2026/04/15 16:14] (current) – [Here are the steps considered the we-measure.io workflow] benjamin
Line 20: Line 20:
   - Start a new measurement for your wing   - Start a new measurement for your wing
   - Measure the wing either directly into we-measure.io or import measurement data from XLSX   - Measure the wing either directly into we-measure.io or import measurement data from XLSX
-  - After all the values are measured & checked for plausiblity/consistency, continue to simulation+  - After all the values are measured & checked for plausiblity/consistency, continue to simulation <alert warning>To trim single lines, stay in the open state, trim and remeasure until you have every line in every group as close to relative zero as possible, then continue to simulation to get an overview about the overall trim</alert>
   - In simulation, use the different tools to check your wing's trim   - In simulation, use the different tools to check your wing's trim
   - If you the trim still meets the requirements of the manufacturer, fine! You can just finish the measurement and continue with the last step. <alert warning>If the trim does **not** meet the requirement of the manufacturer anymore, you should hand it in to a professional check center.</alert>   - If you the trim still meets the requirements of the manufacturer, fine! You can just finish the measurement and continue with the last step. <alert warning>If the trim does **not** meet the requirement of the manufacturer anymore, you should hand it in to a professional check center.</alert>