≪ View Page

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision		Previous revision
en:workflow [2025/12/02 14:55] – created benjaminen:workflow [2025/12/16 19:00] (current) – [Workflow] benjamin
Line 4: Line 4:
   - **Open** <box>Either values are missing or do not qualify for plausibility/consistency. The measurement process itself is not finished yet.</box>   - **Open** <box>Either values are missing or do not qualify for plausibility/consistency. The measurement process itself is not finished yet.</box>
   - **Simulation** <box>The trim check or actual trim is still in progress.</box>   - **Simulation** <box>The trim check or actual trim is still in progress.</box>
-  - **Finished** <box>The trim was either still good or considered as finished (good again).</box>+  - **Finished** <box>The trim was good at the time of measurement or considered as finished after trimming.</box>
  
-Before you start, have a look on the [[toolbar|toolbar]] page, to get a basic understanding for what the buttons do.+==== So you decided to measure your wing's line lengths, as since the last trim check ====
  
-So you decided to measure your wing's line lengths, as since the last trim check +  * the number of flight hours specified by the manufacturer has been reached 
-  * either the number of flight hours specified by the manufacturer has been reached +  * the period of time specified by the manufacturer has elapsed 
-  * or the period of time specified by the manufacturer has elapsed+  * you replaced single line(s) or even the whole line set 
 + 
 + 
 +<alert info>Have a look on the [[toolbar|toolbar]] page first, to get a basic understanding for what the buttons do.</alert> 
 + 
 + 
 +==== Here are the steps considered the we-measure.io workflow ====
  
-Here is a list of steps to follow so that they match the we-measure.io workflow: 
   - Start a new measurement for your wing   - Start a new measurement for your wing
   - Measure the wing either directly into we-measure.io or import measurement data from XLSX   - Measure the wing either directly into we-measure.io or import measurement data from XLSX
Line 22: Line 27:
   - Finish measurement   - Finish measurement
  
-<alert info>What if i already finished