====== Toolbar ======

Pages showing measurements of any status or measurement comparisons always have toolbar on top with different controls and/or actions regarding to the current status.
<alert dark>{{screenshots:buttons:help.png?71 }}
Will open this wiki.
</alert>
<alert dark>{{screenshots:buttons:connect-disconnected.png?71 }}
Connect your BLE laser device.
<br><br><br>
{{screenshots:buttons:connect-connected.png?71 }}
Laser is connected.
</alert>
<alert dark>{{screenshots:buttons:full-reset.png?71 }}
To reset all readings in the current measurement.<br>
This button can also be found besides the title of every group. There you can delete readings for only one group.
</alert>
<alert dark>{{screenshots:buttons:reset-loops.png?71 }}
Reset changed loops in simulation/result.
</alert>
<alert dark>{{screenshots:buttons:print.png?71 }}
Print current measurement/comparison. <br>
In the print dialog you can then either export as PDF or actually print it.
</alert>
<alert dark>{{screenshots:buttons:save.png?71 }}
During measurement, all readings are sent and saved to the server. <br>
When editing a draft, all comments, loops and further settings are sent and saved to the server.
</alert>
<alert dark>{{screenshots:buttons:edit.png?71 }} 
During measurement, change measurement presets.<br>
During simulation you can update preselected loops here.
</alert>
<alert dark>{{screenshots:buttons:settings.png?71 }}
During simulation, change tolerance and offset. The offset will be saved as you finish the measurement, so that the result is easier to read later on.
</alert>
<alert dark>{{screenshots:buttons:draft.png?71 }}
To create a new draft from a measurement in simulation. The link can then be shared and updated by other users.
</alert>
<alert dark>{{screenshots:buttons:share-link.png?71 }}
To share a finished measurement or measurement in simulation.<br>
During comparison, share the comparison.<br>
<br>
These links are accessible to everyone in possession of them. Comments, however, are only visible to logged-in users and only if enabled.
</alert>
<alert dark>{{screenshots:buttons:start-enabled.png?115 }}
Once the laser is connected, you can start measurement mode here.
<br><br><br>
{{screenshots:buttons:start-disabled.png?115 }}
If no empty readings are left (the measurement is complete), the button is disabled.
</alert>
<alert dark>{{screenshots:buttons:import-xlsx-neutral.png?71 }}
Import measurement from XLSX.
<br><br><br>
{{screenshots:buttons:import-xlsx-warn.png?71 }}
In case you added manual values, the orange color is the hint to import data from XLSX instead of typing one by one.
</alert>

<alert dark>{{screenshots:buttons:next-enabled-good.png?71 }}
If no empty readings are left and the data seems plausable, the button is **green**.
<br><br><br>
{{screenshots:buttons:next-enabled-neutral.png?71 }}
If data is complete, but does contain outliers.
</alert>
<alert dark>{{screenshots:buttons:export-xlsx.png?71 }}
To export readings from simulation/Result.
</alert>
<alert dark>{{screenshots:buttons:comparison-start.png?71 }}
To start comparing one result with another.
<br><br><br>
{{screenshots:buttons:comparison-active.png?146 }}
The {{icons:delete.svg?20x20}} will cancel comparison and return to the result designated as "After".
</alert>
<alert dark>{{screenshots:buttons:aoi-symmetry-toggle.png?146 }}
Switch between [[angle-of-incidence-view|AoI view]] and [[symmetry-view|symmetry view]] in simulation and result.
</alert>