Re-measure

In case you selected, that you would like to re-measure the wing, you can then select, which readings should be re-set. If only single main lines are selected here, for all other main lines and their accompanying suspension points, the readings will be copied from the initial measurement.

This way of re-measuring your wing only makes sense, if you directly do it after the initial measurement. If you fly the wing in between, we highly recommend to do a complete new measurement.

You then have the possibility to add some comments that would also appear in the final protocol.

This can - for instance - be used, if you realized damages on your wing, if you would like to protocol changes in trim, like a splice in some lines, other than loops on the main lines etc.

In this step you can also add changes on cascade loops or line insert.

Additionally, we added a feedback form and are looking forward to hearing about your measurement experience through this.

In case, you selected the re-measurement option, in the next step you are forwarded to the measurement page again to re-measure the selected main lines.

If you didn't select any changes, your measurement will be finished and you will reach the result page.

Once again, be aware that trimming your wing has dangers and that you are fully aware that everything you change on a wing and the resulting behaviour in flight is of your own responsibility!